COWL NECK PATTERN TUTORIAL

Feedback and comments are highly appreciated. Also plan to open a flicker pool, in case you happen to use any of my tutorials, i would be happy to see how your creations turned out.

Depending on the response for this tute, i plan to do some tutorials in future. Have a few ideas in mind, may be i shall have a poll and whichever gets your votes, will get featured. What say?

COWL NECK PATTERN DRAFT

STEP 1

STEP 2

STEP 3

• Cut Out the Traced Pattern on the outline
• Cut Along Slashed Lines Upto Shoulder Tip and Upto Bust Point, Take care not to cut through them
• Take another Paper wide and Long enough to accomdate cowl
• Mark a Point 4 inches from the top of the folded paper. Name it as T
• Place above cut pattern on folded paper such that

1. SX touches the guideline
2. Center Front gets positioned on the fold at the point below bust level

STEP 4

>

• Fold on SX Line. Cut Out Pattern across all 4 layers of paper starting from S , till S to TS
• Then Unfold the SX Line and then cut remaining TS-A, A-W, W-D, D-D1, D1-F
• From Z Draw Curved Line to Join Point T
• Cut along the curved Line

STEP 5

STEP 6

Place the pattern on bias grain of folded fabric. Yellow paper is to be assumed as fabric and the cowl neck pattern is placed on bias grain line on fold.

Important Note: Test fit this pattern and if you feel neck is gaping too much then try this adjustment slightly move the Cowl pattern placed on fabric outwards from Shoulder to Neck Depth till where you feel it is gaping.

See the picture below where the pattern is slightly placed outside of fabric fold from Shoulder till a certain neck depth so that gaping can be cut out and the cowl will drape elegantly and modesty will also be maintained.

Comments, Queries ,are most welcome!